THE GRAPHIC MODEL AND THE CONSTRUCTIVE-FUNCTIONAL ANALYSIS OF A NORMALLY OPEN DIRECT-ACTING VALVE

Authors

  • Nicusor Baroiu Ph.D. Eng. Dunarea de Jos University of Galati
  • Georgiana - Alexandra Costin Eng. Dunarea de Jos University of Galati

Keywords:

valve, direct-acting, spring, flow, screw, opening force

Abstract

The valves are elements which provide the opening of a hydraulic circuit when the flow in one direction exceeds a certain value. This paper presents the basic concepts about valves, in general, and also the 3D graphic model of a normally open direct-acting valve in the Autodesk Inventor design environment, respectively, an analysis of such a valve, both functionally and constructively, as well as from the point of view of a calculation of forces acting on some elements of the valve. At the same time, carry out the CAM simulation in the manufacturing process of the mark "Screw".

Downloads

Download data is not yet available.

Author Biographies

Nicusor Baroiu Ph.D. Eng., Dunarea de Jos University of Galati

Associate Professor Department of Manufacturing Engineering

Georgiana - Alexandra Costin Eng., Dunarea de Jos University of Galati

Master student Department of Manufacturing Engineering

Downloads

Published

2019-05-20

Issue

Vol. 14 No. 1 (2019): Issue 1

Section

Engineering Computer Graphics

License

Copyright (c) 2020 Journal of Industrial Design and Engineering Graphics

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.